RE: RE: RE: RE: RE: True width of mineralization Buckshot,
You miss understand me I think, or i am not clear in my post, a 20-30degree angle to core axis on a vertical drill hole equates to a 60-70degree dip or sub-vertical, i think this is shown well on the section 1210-1214, true width would be from 35-45% of downhole intersection.
On section 1213-1217 it is a little more unclear, when the results come in for hole 1216 this should remove some of the confusion.
The reverse nature of the Bor Fault is also difficult to predict, these are just my thoughts and I may be well off, just from what they have released, these are my initial musings. I think it is very premature to start talking about a 250m wide by 400m deep ore body like some, would be nice though!!!
This is a good discussion on this BB, one of the best currently going on and always good to through around a few ideas between investors.
TS