Talon Metals Corp T.TLO

In comparison....

[Seahawk001]

Who would be knowledgeable enough to compare Talon to CNC? 
I bought a small chunk at .31 and 75,000 in the .50's
im out of CNC now after a pretty good run and switched sides of the border, if this runs up anywhere near CNC there will be a lot of happy campers :) 
Go Tlo  Go Bucs

[apapas1973]

Lucky you. You got in early for both.I own both. Some tlo in the low 40's and 50's but unfortunately a little late to the party for cnc. Just started buying recently.

[Seahawk001]

Lol no that's my Talon purchase.. 75,000 of cnc at .50 would have been a nice payday. I did ok on cnc but ya for now I think it's run up where it's going to stay for now.  Im no expert nor do I do a whole lot of DD I just buy while following a stock or owning for awhile.  CNC was at .59 at one point as well so just curious if there's any similarities here? 

[apapas1973]

Yeah i do a little DD but like you not too much. I mean i don't dig into the numbers very much. I probably would confuse myself more than anything. Lol. But I'm with you. I think there's alot going for tlo. If i recall there's only one other decent grade mine in the US at end of life. About 3 or 4 years left. The name slips my mind. The only other one of potential value known so